How to apply a WATER-MELON™ Alco-Activated Appliance™ ("OPEN SESSION")

With an Airbrush and AGPC

Materials: Alco-Activator™ , Duracolor™  Alco-Activated Colors™  or A.G.P.C. Airbrush Foundation, cotton swabs
Apply Alco-Activator™ (99% Isopropyl Alcohol) liberally to the area the appliance is to be attached to. Apply Red Duracolor™ or A.G.P.C. to the cut. No need to be pretty or perfect. You can clean overspray with alcohol on a cotton swab.
Place the appliance into the still wet Alco-Activator™. Try to remove as many air pockets under the piece as possible. press and hold the appliance in place until it bonds. Apply red Duracolor™ to any area outside the cut that should have blood or spatter A.G.P.C. with the airbrush.
Continue laying the appliance into the alcohol, pressing as you go. Keep the pattern random but at the same time logical. The blood should have a reason but also needs to look organic or natural. Not contrived.
Apply Alco-Activator™ to the top of the appliance This makes the appliance almost clear.  Maybe a little blood color though.

 

Then, when you have had enough and are ready to scream just remember when you had to worry about  REMOVAL. Do you have remover? Do you need remover? Not with Water-Melon. It peels off AND is reusable if you're careful when peeling.

Blend the appliance with alcohol this improves the clarity and softens the plastic. Sometimes your finger can help blend the edge too if the Water-Melon™ is soft enough.Tapping your finger on the appliance as it dries will give it a matte finish. Also powdering lightly into the alcohol while still damp will matte as well. No need for foundation.
Apply Duracolor™ Alco-Activated Color™  or A.G.P.C. Airbrush color to the cut. Begin with the darker color to show depth. This kit has Maroon as the darker color.